PaaKJaT的日記本

安裝硬碟後用PUTTY連上WL-HDD

umount硬碟(開機後機器會自動掛載)並重新分割

umount /tmp/mnt/disc0_1
fdisk /dev/discs/disc0/disc

n (new partition)
p (primary partition)
2 (partition number 2)
<enter>(use default)
+10000M (this makes a 10GB partition). This is just preference but should be at least 20MB or so.
t (set partition type)
2 (chooses the second partition- the one we want to be a swap partition)
82 (this hex code tells fdisk that it is a swap partition.
w (this writes the new partition table with your new partitions).

分割完成後格式化分割區

mke2fs -j /dev/discs/disc0/part1 < enter > (this makes an ext3 format filesystem).
mkswap /dev/discs/disc0/part2 < enter > (this creates the swap space).

之後重開機再重新掛載

mount /dev/discs/disc0/part1 /opt < enter >
swapon /dev/discs/disc0/part2 < enter >(如果有建立swap磁區)

建立自動掛載文件(之後重開機就不用再手動掛上)

建立文件

mkdir /usr/local/sbin 
touch /usr/local/sbin/post-boot
touch /usr/local/sbin/post-firewall 
chmod +x /usr/local/sbin/*

啟動vi編輯剛建立的post-boot

#!/bin/sh
mount /dev/discs/disc0/part1 /opt
i=0
while [ $i -le 30 ]
do
if [ -d /opt/etc ]
then
break
fi
sleep 1
i='expr $i + 1'
done
swapon /dev/discs/disc0/part2

編輯完成儲存、離開，然後寫入flash

flashfs save
flashfs commit
flashfs enable
reboot

重開機並檢查是否都完成

REF：http://wlhdd.co.uk/wiki/Main_Page

將opt掛載上了以後就能開始安裝其它套件

首先安裝ipkg

wget http://ipkg.nslu2-linux.org/feeds/optware/oleg/cross/stable/uclibc-opt_0.9.28-13_mipsel.ipk 
ipkg.sh install uclibc-opt_0.9.28-13_mipsel.ipk 
wget http://ipkg.nslu2-linux.org/feeds/optware/oleg/cross/stable/ipkg-opt_0.99.163-10_mipsel.ipk 
ipkg.sh install ipkg-opt_0.99.163-10_mipsel.ipk
ipkg update
ipkg install nano

REF：http://forum.toppy.org.uk/forum/viewtopic.php?p=227904

更改預設網頁設定port

nvram set http_lanport=8080
nvram commit